Checking The Configuration - Huawei quidway s7700 Configuration Manual

Quidway S7700 Smart Routing Switch
Configuration Guide - VPN
The BGP view is displayed.
Step 3 Run:
vpls-family
The BGP-VPLS sub-address family view is displayed.
Step 4 Run:
peer { group-name | ipv4-address } reflect-client
The route reflector (RR) and its client are configured.
Step 5 Run:
undo policy vpn-target
The filtering of VPLS label blocks based on VPN targets is disabled.
Step 6 (Optional) Run:
rr-filter extcomm-filter-number
The reflection policy is configured.
----End

7.3.7 Checking the Configuration

After Kompella VPLS is configured, you can view information about local VSIs, remote VSIs,
and VPLS connections.
Prerequisite
The configurations of the Kompella VPLS function are complete.
Procedure
l
l
l
----End
Example
Run the display vsi [ name vsi-name ] [ verbose ] command. You can view that the item "VSI
State" is displayed as "up". If verbose is selected, the item "Signaling" is displayed as "bgp" and
the item "VC State" is displayed as "up". This means that the configuration succeeds. For
example:
<Quidway> display vsi name bgp1 verbose
***VSI Name
Issue 01 (2011-07-15)
Run the display vsi [ name vsi-name ] [ verbose ] command to check the information about
the VPLS VSI.
Run the display vsi remote bgp [ nexthop nexthop-address [ export-vpn-target vpn-
target ] | route-distinguisher route-distinguisher ] command to check information about
the remote VSI.
Run the display vpls connection [ bgp | vsi vsi-name ] [ down | up ] [ verbose ] command
to check the information about the VPLS connection.
Administrator VSI
Isolate Spoken
VSI Index
PW Signaling
Member Discovery Style : auto
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
: bgp1
: no
: disable
: 0
: bgp
7 VPLS Configuration
689