Huawei quidway s7700 Configuration Manual page 455

Quidway S7700 Smart Routing Switch
Configuration Guide - VPN
3.
4.
5.
Issue 01 (2011-07-15)
Enable MPLS and MPLS LDP on the devices and interfaces along the LSP. The
configuration procedure is not mentioned here.
After the configuration, run the display mpls ldp session command, and you can see in
the display that the Session State item is Operational.
Take the display on PE1 and RR as an example:
<PE1> display mpls ldp session
LDP Session(s) in Public Network
Codes: LAM(Label Advertisement Mode), SsnAge Unit(DDDD:HH:MM)
A '*' before a session means the session is being deleted.
------------------------------------------------------------------------------
PeerID Status
------------------------------------------------------------------------------
2.2.2.9:0 Operational DU
------------------------------------------------------------------------------
TOTAL: 1 session(s) Found.
<RR> display mpls ldp session
LDP Session(s) in Public Network
Codes: LAM(Label Advertisement Mode), SsnAge Unit(DDDD:HH:MM)
A '*' before a session means the session is being deleted.
----------------------------------------------------------------------
Peer-ID Status
----------------------------------------------------------------------
1.1.1.9:0 Operational DU
3.3.3.9:0 Operational DU
----------------------------------------------------------------------
TOTAL: 2 session(s) Found.
Configure IPv6 VPN instances on PEs.
For the configuration procedure, see
Set up the EBGP peer relation between PEs and CEs to import VPN routes.
For the configuration procedure, see
BGP4+).
Set up the MP-IBGP peer relation between PEs and RR.
# Configure PE1.
<PE1> system-view
[PE1] bgp 100
[PE1-bgp] peer 2.2.2.9 as-number 100
[PE1-bgp] peer 2.2.2.9 connect-interface loopback 1
[PE1-bgp] ipv6-family vpnv6
[PE1-bgp-af-vpnv6] peer 2.2.2.9 enable
[PE1-bgp-af-vpnv6] quit
# Configure RR.
<RR> system-view
[RR] bgp 100
[RR-bgp] peer 1.1.1.9 as-number 100
[RR-bgp] peer 1.1.1.9 connect-interface loopback 1
[RR-bgp] peer 3.3.3.9 as-number 100
[RR-bgp] peer 3.3.3.9 connect-interface loopback 1
[RR-bgp] ipv6-family vpnv6
[RR-bgp-af-vpnv6] peer 1.1.1.9 enable
[RR-bgp-af-vpnv6] peer 3.3.3.9 enable
[RR-bgp-af-vpnv6] quit
[RR-bgp] quit
# Configure PE2.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 BGP MPLS IPv6 VPN Configuration
LAM SsnRole SsnAge
Active 0000:09:23
LAM SsnRole SsnAge
Active 000:00:02
Passive 000:00:01
Example for Configuring BGP/MPLS IPv6
Example for Configuring Hub&Spoke (Using
KASent/Rcv
2253/2237
KA-Sent/Rcv
11/11
8/8
VPN.
440