Huawei quidway s7700 Configuration Manual page 748

Quidway S7700 Smart Routing Switch
Configuration Guide - VPN
[PE2] mpls l2vpn
Step 6 Configure VSIs on PEs.
# Configure PE1.
[PE1] vsi a2 static
[PE1-vsi-a2] pwsignal ldp
[PE1-vsi-a2-ldp] vsi-id 2
[PE1-vsi-a2-ldp] peer 3.3.3.9
# Configure PE2.
[PE2] vsi a2 static
[PE2-vsi-a2] pwsignal ldp
[PE2-vsi-a2-ldp] vsi-id 2
[PE2-vsi-a2-ldp] peer 1.1.1.9
Step 7 Bind VSIs to interfaces on PEs.
# Configure PE1.
[PE1] interface vlanif 10
[PE1-Vlanif10] l2 binding vsi a2
[PE1-Vlanif10] quit
# Configure PE2.
[PE2] interface vlanif 40
[PE2-Vlanif40] l2 binding vsi a2
[PE2-Vlanif40] quit
Step 8 Assign an IP address to each VLANIF interface on CEs.
# Configure CE1.
<Quidway> sysname CE1
[CE1] interface vlanif 10
[CE1-Vlanif10] ip address 10.1.1.1 255.255.255.0
[CE1-Vlanif10] quit
# Configure CE2.
<Quidway> sysname CE2
[CE2] interface vlanif 40
[CE2-Vlanif40] ip address 10.1.1.2 255.255.255.0
[CE2-Vlanif40] quit
Step 9 Verify the configuration.
After the preceding configurations, run the display vsi name a2 verbose command on PE1. You
can find that a VSI named a2 sets up a PW to PE2, and the status of the VSI is UP.
.
<PE1> display vsi name a2 verbose
***VSI Name
Issue 01 (2011-07-15)
Administrator VSI
Isolate Spoken
VSI Index
PW Signaling
Member Discovery Style : static
PW MAC Learn Style
Encapsulation Type
MTU
Diffserv Mode
Mpls Exp
DomainId
Domain Name
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
: a2
: no
: disable
: 0
: ldp
: unqualify
: vlan
: 1500
: uniform
: --
: 255
:
7 VPLS Configuration
733