Configuring The Rr To Establish Mp Ibgp Connections With The Client Pes - Huawei quidway s7700 Configuration Manual

Quidway S7700 Smart Routing Switch
Configuration Guide - VPN
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
bgp as-number
The BGP view is displayed.
Step 3 Run:
peer ipv4-address as-number as-number
The RR is specified as the BGP peer.
Step 4 Run:
peer ipv4-address connect-interface interface-type interface-number
The interface is specified as an interface to establish the TCP connection.
The IP address of the interface must be the same as the MPLS LSR ID. It is recommended to
specify a loopback interface to establish the TCP connection.
Step 5 Run:
ipv4-family vpnv4
The BGP VPNv4 address family view is displayed.
Step 6 Run:
peer
The capability of exchanging VPNv4 routes between the PE and the RR is enabled.
----End
3.14.3 Configuring the RR to Establish MP IBGP Connections with
the Client PEs
MP-IBGP connections are configured between the RR and all its clients (PEs) to facilitate
VPNv4 route reflection.
Context
Choose one of the following schemes to configure the RR.
Procedure
l
Issue 01 (2011-07-15)
ipv4-address enable
Configuring the RR to Establish MP IBGP Connections with the Peer Group
1. Run:
system-view
The system view is displayed.
2. Run:
bgp as-number
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 BGP MPLS IP VPN Configuration
162