Enabling The Vpn Binding For A Tunnel - Huawei quidway s7700 Configuration Manual

Quidway S7700 Smart Routing Switch
Configuration Guide - VPN
Pre-configuration Tasks
Before configuring VPN primary tunnel binding, complete the following tasks:
l
l
l
l
l
l
Data Preparation
To configure VPN primary tunnel binding, you need the following data.
No.
1
2
3

1.6.2 Enabling the VPN Binding for a Tunnel

A tunnel can be bound to a VPN only after VPN tunnel binding is enabled.
Context
Only the tunnel enabled with the VPN binding can be bound with the VPN.
Do as follows on PEs at both ends of the TE tunnel.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface tunnel interface-number
The tunnel interface view of the MPLS TE is displayed.
Step 3 Run:
mpls te reserved-for-binding
Issue 01 (2011-07-15)
Connecting the interfaces, configuring physical parameters for the interfaces to ensure that
the physical status of the interfaces is Up
Configuring parameters of the link layer protocol and IP addresses for the interfaces to
ensure the status of the link layer protocol on the interfaces is Up
Configuring the static route or the Interior Gateway Protocol (IGP) to ensure routes are
reachable to all nodes
Configuring basic MPLS functions and enabling MPLS TE
Configuring the MPLS TE tunnels between PEs (refer to the Quidway S7700 Smart Routing
Switch Configuration Guide - MPLS).
Configuring the VPN instance on the PE (refer to the chapter
Configuration" in this manual)
Data
Name of the tunnel policy
QoS parameters for the MPLS TE tunnel such as bandwidth
Name of the VPN instance
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 VPN Tunnel Management Configuration
"3 BGP MPLS IP VPN
20