Huawei quidway s7700 Configuration Manual page 127

Quidway S7700 Smart Routing Switch
Configuration Guide - VPN
l
l
Issue 01 (2011-07-15)
4. Run:
import-route { direct | static | rip process-id | ospf process-id | isis
process-id } [ med med | route-policy route-policy-name ]*
The route is imported to the local CE.
The CE advertises its VPN network segment to the connected PE, and the PE then
advertises the address to the remote CE. Note that the type of the imported route may
vary with different networking modes.
Configure the static route between a PE and a CE.
Do as follows on the PE. The CE is configured with the static route, and the configurations
are common, therefore not mentioned here.
NOTE
For details, see Quidway S7700 Smart Routing Switch Configuration Guide - IP Routing.
1. Run:
system-view
The system view is displayed.
2. Run:
ip route-static vpn-instance vpn-source-name destination-address { mask
| mask-length } interface-type interface-number [ nexthop-address ]
[ preference preference | tag tag ]
The static route is configured for the specified VPN instance.
3. Run:
bgp as-number
The BGP view is displayed.
4. Run:
ipv4-family vpn-instance vpn-instance-name
The BGP VPN instance view is displayed.
5. Run:
import-route static [ med med | route-policy route-policy-name ]*
The configured static route is imported into the routing table of the BGP VPN instance.
Configure RIP between a PE and a CE
Do as follows on the PE. The CE is configured with RIPv1 or RIPv2, and the configurations
are common, therefore not mentioned here.
NOTE
For details, see Quidway S7700 Smart Routing Switch Configuration Guide - IP Routing.
1. Run:
system-view
The system view is displayed.
2. Run:
rip process-id vpn-instance vpn-instance-name
The RIP instance is created between the PE and the CE and the RIP view is displayed.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 BGP MPLS IP VPN Configuration
*
112