Creating A Remote Ccc Connection - Huawei quidway s7700 Configuration Manual

Quidway S7700 Smart Routing Switch
Configuration Guide - VPN
Context
The local CCC connection is bidirectional, and thus only one connection is required.
Do as follows on the PEs:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
ccc ccc-connection-name interface interface-type1 interface-number1 [ raw |
tagged ] out-interface interface-type2 interface-number2 [ raw | tagged ]
A local CCC connection is created.
The S7700 can create a local CCC connection only on the VLANIF interface. By default, the
raw encapsulation type is adopted.
----End
Follow-up Procedure
After the configuration mentioned above on the PE, a local CCC connection is created.

5.3.4 Creating a Remote CCC Connection

This part describes how to create a remote CCC connection. To create the remote CCC
connection, you need to configure the incoming and outgoing interfaces and set the incoming
label and outgoing label for the CCC connection on the local and remote PEs. In addition, you
need to configure two bidirectional static LSPs on the P device. The remote CCC connection is
unidirectional and thus two such connections need to be created.
Procedure
l
l
Issue 01 (2011-07-15)
Configuring the PE
Do as follows on the PEs of the two ends of the VC:
1. Run:
system-view
The system view is displayed.
2. Run:
ccc ccc-connection-name interface interface-type1 interface-number1 [ raw
| tagged ] in-label in-label-value out-label out-label-value nexthop
nexthop-address [ control-word | no-control-word ]
A remote CCC connection is configured.
On the PE or P, the remote CCC connection can be configured only on the VLANIF
interface. You must use nexthop to specify the IP address of the next hop. By default,
the remote CCC connection adopts the raw encapsulation type.
Configuring P
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 VLL Configuration
456