Huawei quidway s7700 Configuration Manual page 59

Quidway S7700 Smart Routing Switch
Configuration Guide - VPN
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
Procedure
Step 1 Enable PEs to communicate with each other.
# Configure an Interior Gateway Protocol (IGP) on the MPLS backbone network to implement
interworking between the PEs. IS-IS is used in this example, and the IS-IS process ID is 1.
# Configure PE1.
<Quidway> system-view
[Quidway] sysname PE1
[PE1] vlan 7
[PE1-vlan7] quit
[PE1] interface gigabitethernet 1/0/1
[PE1-GigabitEthernet1/0/1] port hybrid pvid vlan 7
[PE1-GigabitEthernet1/0/1] port hybrid tagged vlan 7
[PE1-GigabitEthernet1/0/1] quit
[PE1] interface vlanif 7
[PE1-Vlanif7] ip address 100.1.1.2 24
[PE1-Vlanif7] quit
[PE1]isis 1
[PE1-isis-1] network-entity 10.0000.0000.0000.0001.00
[PE1-isis-1] is-level level-2
[PE1-isis-1] quit
[PE1] interface vlanif 7
[PE1-Vlanif7] isis enable 1
[PE1-Vlanif7] quit
[PE1] interface loopback 1
[PE1-LoopBack1] ip address 1.1.1.9 32
[PE1-LoopBack1] isis enable 1
[PE1-LoopBack1] quit
# The configuration procedures of PE2 and PE3 are similar to the configuration procedure of
PE1.
# Configure the P.
Issue 01 (2011-07-15)
Configure a TE tunnel.
Configure a tunnel policy to bind the IP address of the remote end to the tunnel.
Apply the tunnel policy to the L2VC.
Connect the CEs to the backbone network.
Tunnel policy
VC ID
Parameters for the MPLS TE tunnel
NOTE
For different L2VPN services from a PE to the same destination, different tunnel policies and TE tunnels
are required.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 VPN Tunnel Management Configuration
44