Example For Configuring A Dynamic Sh-Pw - Huawei quidway s7700 Configuration Manual

Quidway S7700 Smart Routing Switch
Configuration Guide - VPN

6.13.1 Example for Configuring a Dynamic SH-PW

Networking Requirements
As shown in
An LSP needs to be used to set a dynamic PW between PE1 and PE2.
Figure 6-12 Networking diagram for configuring a dynamic SH-PW (using LSP)
192.2.2.2/32
Device
PE1
PE2
P
CE1
CE2
Configuration Roadmap
The configuration roadmap is as follows:
Issue 01 (2011-07-15)
Figure 6-12, PE1 and PE2 are connected through an MPLS backbone network.
Loopback0
GE2/0/0
PE1 GE1/0/0
GE1/0/0
CE1
Interface
GigabitEthernet1/0/0
GigabitEthernet2/0/0
Loopback1
GigabitEthernet1/0/0
GigabitEthernet2/0/0
Loopback1
GigabitEthernet1/0/0
GigabitEthernet2/0/0
Loopback1
GigabitEthernet1/0/0
GigabitEthernet1/0/0
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
MPLS Backbone
Loopback0
192.4.4.4/32
GE1/0/0 GE2/0/0
P
PW
VLANIF interface
VLANIF 10
VLANIF 20
-
VLANIF 30
VLANIF 40
-
VLANIF 20
VLANIF 40
-
VLANIF 10
VLANIF 30
6 PWE3 Configuration
Loopback0
192.3.3.3/32
GE2/0/0
GE1/0/0
PE2
GE1/0/0
CE2
IP address
-
10.1.1.1/24
192.2.2.2/32
-
10.2.2.2/24
192.3.3.3/32
10.1.1.2/24
10.2.2.1/24
192.4.4.4/32
100.1.1.1/24
100.1.1.2/24
589