Enabling Mpls L2Vpn; Creating A Martini Vll Connection - Huawei quidway s7700 Configuration Manual

Quidway S7700 Smart Routing Switch
Configuration Guide - VPN

5.5.2 Enabling MPLS L2VPN

Before configuring a Martini VLL, you must enable MPLS L2VPN.
Context
Do as follows on the PEs of the two ends of the VC:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
mpls l2vpn
The MPLS L2VPN is enabled.
----End

5.5.3 Creating a Martini VLL Connection

Context
Do as follows on the PEs on the two ends of the VC.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
mpls l2vpn
The MPLS L2VPN view is displayed.
Step 3 Run:
mpls l2vpn default martini
The Martini mode is enabled.
Issue 01 (2011-07-15)
NOTE
l By default, the S7700 uses pseudo wire emulation edge-to-edge (PWE3) mode. The PWE3 mode can
use Notification messages to negotiate the PW status. The Martini mode, however, does not support
Notification messages. For details about Notification messages, see the chapter
PWE3.
l If the peer PE does not support Notification messages, you need to set the mode to Martini by using
the mpls l2vpn default martini command.
l Before using the mpls l2vpn default martini command to enable the Martini mode that does not
support Notification messages, delete the VC configuration related to notification messages, including
the PWE3 configuration and VSI configuration.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 VLL Configuration
6.1 Introduction to
462