Huawei quidway s7700 Configuration Manual page 31

Quidway S7700 Smart Routing Switch
Configuration Guide - VPN
l
l
Issue 01 (2011-07-15)
2. Run:
interface interface-type interface-number
The view of the interface connected with the CE is displayed.
3. Run:
mpls l2vc ip-address vc-id tunnel-policy policy-name
A tunnel policy is applied to the VC of the VLL in Martini mode.
Applying a tunnel policy to VLL in Kompella mode
Do as follows on PEs configured with VCs:
1. Run:
system-view
The system view is displayed.
2. Run:
mpls l2vpn vpn-name
The MPLS L2VPN instance view is displayed.
3. Run:
ce ce-name
The MPLS L2VPN CE view is displayed.
4. Run:
connection [ ce-offset id ] interface interface-type interface-number
tunnel-policy policy-name
A tunnel policy is applied to the VC of the VLL in Kompella mode.
NOTE
Before configuring Kompella VLL on a PE, create a connection with a CE by running the ce
ce-name id ce-id [ range ce-range ] [ default-offset ce-offset ] command.
Applying a tunnel policy to VPLS in Martini mode
Do as follows on the PEs at both ends of a PW:
1. Run:
system-view
The system view is displayed.
2. Run:
vsi vsi-name [ auto | static ]
A VSI is created.
3. Run:
pwsignal ldp
LDP is configured as the PW signaling protocol and the VSI-LDP view is displayed.
4. Run:
vsi-id vsi-id
The VSI ID is set.
5. Run:
peer peer-address [ negotiation-vc-id vc-id ] [ tnl-policy policy-name ]
The VSI peer relationship is configured and a tunnel policy is applied to the peer.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 VPN Tunnel Management Configuration
16