Huawei quidway s7700 Configuration Manual page 777

Quidway S7700 Smart Routing Switch
Configuration Guide - VPN
UPE2
CE1
CE2
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
Procedure
1.
2.
Issue 01 (2011-07-15)
Loopback1
GigabitEthernet 1/0/0
GigabitEthernet 2/0/0
Loopback1
GigabitEthernet 1/0/0
GigabitEthernet 1/0/0
Complete the task of Configuring Martini VPLS between SPEs.
Configure basic MPLS L2VPN functions on UPEs and SPEs.
Configure static VLLs and VSIs on SPEs and enable MAC-withdraw function on the VSIs.
Configure UPEs to access SPEs through static VLLs.
Names and IDs of VSIs
MPLS LSR IDs of UPEs and SPEs, which are used as peer IP addresses
Routing protocol
Received and sent labels on static LSPs between UPEs and SPEs
Configure IP addresses for interfaces.
As shown in Figure 7-16, configure the VLAN to which each interface belongs, and
configure the IP addresses and masks for loopback interfaces and VLANIF interfaces. The
details are not mentioned here.
NOTE
Do not add the AC-side port and PW-side port of a PE to the same VLAN; otherwise, a loop may
occur.
Configure an IGP.
Configure OSPF on SPEs and the P device to advertise the network segment and LSR IDs.
# Configure SPE1.
<SPE1> system-view
[SPE1] ospf
[SPE1-ospf-1] area 0
[SPE1-ospf-1-area-0.0.0.0] network 1.1.1.9 0.0.0.0
[SPE1-ospf-1-area-0.0.0.0] network 100.1.1.0 0.0.0.255
[SPE1-ospf-1-area-0.0.0.0] network 100.1.3.0 0.0.0.255
[SPE1-ospf-1-area-0.0.0.0] quit
[SPE1-ospf-1] quit
# Configure P.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
-
VLANIF 50
VLANIF 60
-
VLANIF 10
VLANIF 60
7 VPLS Configuration
3.3.3.9/32
100.1.4.2/24
-
5.5.5.9/32
10.1.1.1/24
10.1.1.2/24
762