Checking The Configuration - Huawei quidway s7700 Configuration Manual

Quidway S7700 Smart Routing Switch
Configuration Guide - VPN
l
----End
Follow-up Procedure
Choose one of the preceding methods as required. For detailed configurations, see
a Routing Protocol Between PE and

3.5.7 Checking the Configuration

After the networking of Hub and Spoke is configured, you can view VPN routing information
on the PE or CE.
Prerequisite
The configurations of the Hub and Spoke function are complete.
Procedure
l
Issue 01 (2011-07-15)
In this way, instead of BGP, IGP or static routes are adopted between the Spoke-PE and
the Spoke-CE. For details, refer to the chapter "BGP/MPLS IP VPN" in the Quidway
S7700 Smart Routing Switch Feature Desripiton- VPN.
Configuring static routes between the Hub-PE and the Hub-CE
In this way, EBGP, IGP, or static routes can be adopted between the Spoke-PE and the
Spoke-CE.
If the Hub-CE uses the default route to access the Hub-PE, to advertise the default route to
all the Spoke-PEs, do as follows on the Hub-PE:
1. Run:
system-view
The system view is displayed.
2. Run:
ip route-static vpn-instance vpn-source-name 0.0.0.0 0.0.0.0 nexthop-
address [ preference preference | tag tag ]
Here, vpn-instance-name refers to the VPN-out. nexthop-address is the IP address of
the Hub-CE interface that is connected with the PE interface bound with the VPN-
out.
3. Run:
bgp as-number
The BGP view is displayed.
4. Run:
ipv4-family vpn-instance vpn-instance-name
The BGP VPN instance view is displayed. vpn-instance-name refers to the VPN-out.
5. Run:
network 0.0.0.0 0
Advertise the default route to all the Spoke-PEs through MP-BGP.
Run the display ip routing-table vpn-instance vpn-instance-name command to check
routing information about the VPN-in and VPN-out on the Hub-PE.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 BGP MPLS IP VPN Configuration
*
[ description text ]
CE.
Configuring
124