Huawei quidway s7700 Configuration Manual page 791

Quidway S7700 Smart Routing Switch
Configuration Guide - VPN
[UPE1] mpls l2vpn
[UPE1] mpls l2vpn default martini
[UPE1-l2vpn] quit
[UPE1] interface vlanif 50
[UPE1-Vlanif50] mpls l2vc 1.1.1.9 100
[UPE1-Vlanif50] quit
# Configure UPE2.
[UPE2] mpls l2vpn
[UPE2-l2vpn] quit
[UPE2] interface vlanif 60
[UPE2-Vlanif60] mpls l2vc 3.3.3.9 100
[UPE2-Vlanif60] quit
Step 7 Enable the MPLS L2VPN function and configure VSIs on SPEs.
# Configure SPE1.
[SPE1] mpls l2vpn
[SPE1-l2vpn] quit
[SPE1] vsi v100 static
[SPE1-vsi-v100] pwsignal ldp
[SPE1-vsi-v100-ldp] vsi-id 100
[SPE1-vsi-v100-ldp] peer 3.3.3.9
[SPE1-vsi-v100-ldp] peer 4.4.4.9 upe
[SPE1-vsi-v100-ldp] quit
# Configure SPE2.
[SPE2] mpls l2vpn
[SPE2-l2vpn] quit
[SPE2] vsi v100 static
[SPE2-vsi-v100] pwsignal ldp
[SPE2-vsi-v100-ldp] vsi-id 100
[SPE2-vsi-v100-ldp] peer 1.1.1.9
[SPE2-vsi-v100-ldp] peer 5.5.5.9 upe
[SPE2-vsi-v100-ldp] quit
Step 8 Verify the configuration.
After the configuration, run the display mpls l2vc command on the UPEs. You can find that the
dynamic VLLs are established and the VC status is Up. Take the display on UPE1 as an example.
[UPE1] display mpls l2vc
total LDP VC : 1
*client interface
session state
AC status
VC state
VC ID
VC type
destination
local VC label
control word
forwarding entry
local group ID
manual fault
active state
link state
local VC MTU
tunnel policy name
traffic behavior name: --
PW template name
primary or secondary : primary
create time
up time
last change time
Issue 01 (2011-07-15)
1 up 0 down
: Vlanif50
: up
: up
: up
: 100
: VLAN
: 1.1.1.9
: 23552
: disable
: exist
: 0
: not set
: active
: up
: 1500
: --
: --
: 0 days, 0 hours, 7 minutes, 55 seconds
: 0 days, 0 hours, 4 minutes, 58 seconds
: 0 days, 0 hours, 4 minutes, 58 seconds
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
remote VC label
remote VC MTU
7 VPLS Configuration
: 23552
: 1500
776