Huawei quidway s7700 Configuration Manual page 618

Quidway S7700 Smart Routing Switch
Configuration Guide - VPN
S-PE
CE1
CE2
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
5.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
l
Procedure
Step 1 Configure interface addresses for CE, U-PE,P and S-PE according to
VLAN and VLANIF interfaces.
The configuration procedure is not mentioned.
Step 2 Configure an IGP protocol on the MPLS backbone network.
Configure an IGP protocol on the MPLS backbone network. OSPF is used as the IGP protocol
in this example.
Configure interface addresses of the U-PE, S-PE, and P. When configuring OSPF, note that the
32-bit loopback interfaces of U-PE1, S-PE, and U-PE2 must be advertised.
The configuration procedure is not mentioned.
After the configuration, run the display ip routing-table command on U-PE, P, or S-PE, and
you can see that the devices can learn each other's routes. Take the display on S-PE for example.
Issue 01 (2011-07-15)
GigabitEthernet2/0/0
Loopback0
GigabitEthernet1/0/0
GigabitEthernet2/0/0
Loopback0
GigabitEthernet1/0/0
GigabitEthernet1/0/0
Run an IGP protocol on the devices of the backbone network to implement connectivity.
Configure the basic MPLS functions on the backbone network and set up an LSP. Set up
MPLS LDP peer relations between U-PE1 and S-PE, and between U-PE2 and S-PE.
Create a PW template. Enable the CW and LSP ping function.
Configure the dynamic PW on the U-PE.
Create a switching PW on the switching node S-PE.
L2VC IDs on U-PE1 and U-PE2 (the L2VC IDs should be different)
MPLS LSR-IDs of U-PE1, S-PE, and U-PE2
IP addresses of the remote peers
Encapsulation type of the switching PW
Name and parameters of the PW template on U-PEs
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
VLANIF 50
-
VLANIF 30
VLANIF 40
-
VLANIF 10
VLANIF 60
6 PWE3 Configuration
40.1.1.1/24
4.4.4.9/32
20.1.1.2/24
30.1.1.1/24
3.3.3.9/32
100.1.1.1/24
100.1.1.2/24
Figure 6-14, including
603