Huawei quidway s7700 Configuration Manual page 667

Quidway S7700 Smart Routing Switch
Configuration Guide - VPN
# Configure U-PE1.
[U-PE1] mpls l2vpn
[U-PE1-l2vpn] quit
[U-PE1] interface vlanif 10
[U-PE1-Vlanif10] mpls l2vc pw-template pwt 100
[U-PE1-Vlanif10] quit
# Configure S-PE.
[S-PE] mpls l2vpn
[S-PE-l2vpn] quit
[S-PE] mpls switch-l2vc 1.1.1.9 100 between 5.5.5.9 200 encapsulation vlan
# Configure U-PE2.
[U-PE2] mpls l2vpn
[U-PE2-l2vpn] quit
[U-PE2] interface vlanif 60
[U-PE2-Vlanif60] mpls l2vc pw-template pwt 200
[U-PE2-Vlanif60] quit
After the preceding configuration, run the display mpls l2vc interface command on U-PEs to
check L2VPN connections. You can see that PWs are set up and in Active state. In addition, you
can find that the BFD for PW function is disabled on the PWs.
Take the display on U-PE1 for example.
<U-PE1> display mpls l2vc interface vlanif 10
*client interface
Administrator PW
session state
AC state
VC state
VC ID
VC type
destination
local group ID
local VC label
local AC OAM State
local PSN State
local forwarding state : forwarding
local status code
remote AC OAM state
remote PSN state
remote forwarding state: forwarding
local status code
BFD for PW
manual fault
active state
forwarding entry
link state
local VC MTU
local VCCV
remote VCCV
local control word
tunnel policy
traffic behavior
PW template name
primary or secondary
VC tunnel/token info
create time
Issue 01 (2011-07-15)
NOTE
PWE3 does not support point-to-multipoint (P2MP). When you create an MPLS L2VC on an ATM sub-
interface, the ATM sub-interface must be in the point-to-point (P2P) type. When you configure the
transparent transmission of ATM cells, the type of the ATM sub-interface is not restricted.
NO.0 TNL type : lsp
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
: Vlanif10 is up
: no
: up
: up
: up
: 100
: VLAN
: 3.3.3.9
: 0 remote group ID
: 23552 remote VC label
: up
: up
: 0x0
: up
: up
: 0x0
: available
: not set
: active
: exist
: up
: 1500 remote VC MTU
: cw alert lsp-ping bfd
: cw alert lsp-ping bfd
: enable remote control word
: --
: --
: pwt
: primary
: 1 tunnels/tokens
, TNL ID : 0x20023
: 0 days, 0 hours, 2 minutes, 40 seconds
6 PWE3 Configuration
: 0
: 23552
: 1500
: enable
652