Configuring The Static Vll To Access The Vpls Network; Establishing The Configuration Task - Huawei quidway s7700 Configuration Manual

Quidway S7700 Smart Routing Switch
Configuration Guide - VPN
......
Run the display vsi remote ldp [ router-id ip-address ] [ pw-id pw-id ] command. If information
about the remote VSI established through LDP is displayed, it means that the configuration
succeeds. For example:
<Quidway> display vsi remote ldp
Vsi
ID
123

7.6 Configuring the Static VLL to Access the VPLS Network

This section describes how to configure a static VLL to access a UPE to an SPE (a VPLS
network). The configuration is needed if the UPE does not support dynamic VLLs and needs to
access the SPE through the static VLL.

7.6.1 Establishing the Configuration Task

Before configuring a static VLL to access the VPLS network, familiarize yourself with the
applicable environment, complete the pre-configuration tasks, and obtain the required data. This
can help you complete the configuration task quickly and accurately.
Applicable Environment
In the practical network such as a MAN, if a UPE device does not support the dynamic VLL,
the UPE device has to access the SPE through the static VLL. In this case, the VLL set up between
the UPE and the SPE is generally in SVC mode.
Pre-configuration Tasks
Before configuring the static VLL to access the VPLS network, complete the following tasks:
l
l
l
l
l
Data Preparation
To configure the static VLL to access the VPLS network, you need the following data.
No.
1
2
3
Issue 01 (2011-07-15)
VSI State
Peer
RouterID
3.3.3.9
Configuring IGP on the SPE and P devices in the MPLS backbone network to ensure the
IP connectivity
Realizing the connectivity between the SPE devices in the VPLS meshed network
Setting up a dynamic LSP or a static LSP between the UPE and the SPE devices
Enabling MPLS L2VPN on the interfaces connected the UPE and the SPE devices
Configuring the tunnel policy
Data
Mappings between the UPE and the SPE devices
IP address of the peer
VSI name, VSI ID, the interface bound with the VSI
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
: up
VC Group Vsi
Label ID Type
17408 0 vlan
7 VPLS Configuration
MTU Vsi State
Value Index Code
1500 1 FORWARD
700