Huawei quidway s7700 Configuration Manual page 762

Quidway S7700 Smart Routing Switch
Configuration Guide - VPN
After the configuration, run the display this interface command in the tunnel interface view,
and you can view that the value of Line protocol current state is UP. It indicates that the MPLS
TE tunnel is set up successfully. For example, information about PE1 is displayed as follows:
[PE1-Tunnel1/0/0] display this interface
Tunnel1/0/0 current state : UP
Line protocol current state : UP
Description : HUAWEI, Quidway Series, Tunnel1/0/0 Interface
Route Port,The Maximum Transmit Unit is 1500 bytes
Internet Address is unnumbered, using address of LoopBack1(1.1.1.9/32)
Encapsulation is TUNNEL, loopback not set
Tunnel destination 3.3.3.9
Tunnel up/down statistics 16
Tunnel protocol/transport MPLS/MPLS, ILM disabled
QoS max-bandwidth : 64 Kbps
Output queue : (Urgent queue : Size/Length/Discards)
Output queue : (Protocol queue : Size/Length/Discards) 0/1000/0
Output queue : (FIFO queue : Size/Length/Discards)
Run the display tunnel-info all command in the system view, and you can view that the TE
tunnel with the destination address being the peer MPLS LSR ID exists between PEs. For
example, information about PE1 is displayed as follows:
<PE1> display tunnel-info all
* -> Allocated VC Token
Tunnel ID
----------------------------------------------------------------------
0x10020
0x10021
0x10022
Step 6 Configure remote LDP sessions.
Set up remote peer sessions between PE1 and PE2.
# Configure PE1.
[PE1] mpls ldp
[PE1-mpls-ldp] quit
[PE1] mpls ldp remote-peer 3.3.3.9
[PE1-mpls-ldp-remote-3.3.3.9] remote-ip 3.3.3.9
[PE1-mpls-ldp-remote-3.3.3.9] quit
# Configure PE2.
[PE2] mpls ldp
[PE2-mpls-ldp] quit
[PE2] mpls ldp remote-peer 1.1.1.9
[PE2-mpls-ldp-remote-1.1.1.9] remote-ip 1.1.1.9
[PE2-mpls-ldp-remote-1.1.1.9] quit
After the configuration, an LDP session can be successfully set up between PEs.
For example, information about PE1 is displayed as follows:
<PE1> display mpls ldp session
LDP Session(s) in Public Network
Codes: LAM(Label Advertisement Mode), SsnAge Unit(DDDD:HH:MM)
A '*' before a session means the session is being deleted.
Issue 01 (2011-07-15)
300 seconds output rate 0 bits/sec, 0 packets/sec
0 seconds output rate 0 bits/sec, 0 packets/sec
0 packets output, 0 bytes
0 output error
0 output drop
Input bandwidth utilization
Output bandwidth utilization : --
Type
cr lsp
lsp
lsp(*)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
0/256/0
: --
Destination
3.3.3.9
--
--
7 VPLS Configuration
0/50/0
Token
0
1
2
747