Huawei quidway s7700 Configuration Manual page 499

Quidway S7700 Smart Routing Switch
Configuration Guide - VPN
VC last up time
VC total up time
CKey
NKey
PW redundancy mode
AdminPw interface
AdminPw link state
reroute policy
reason of last reroute
time of last reroute
delay timer ID
resume timer ID
Run the display mpls l2vc remote-info command, and you can see that Peer Addr is the peer
address of the VC. The following is an example:
<Quidway> display mpls l2vc remote-info
Total remote ldp vc : 2
Transport
VC ID
100
200
Run the display mpls l2vpn connection interface command, and you can see that the local VC
status and remote VC status of the master PW and the backup PW are both Up, the forwarding
state of the master PW is true, and the forwarding state of the backup PW is false. The BFD
session is Up.
<Quidway> display mpls l2vpn connection interface vlanif 11
conn-type: remote
tunnel type: cr lsp,
conn-type: remote
Issue 01 (2011-07-15)
: 2010/12/01 10:00:00
: 0 days, 2 hours, 20 minutes, 0 seconds
: 5
: 3
: --
: --
: --
: delay 30 s, resume 10 s
: --
: -- days, -- hours, -- minutes, -- seconds
: --
: --
Group Peer
ID Addr
0 11.11.11.11
0 11.11.11.11
local vc state:
remote vc state:
local ce-id:
local ce name:
remote ce-id:
intf(state,encap):
peer id:
route-distinguisher:
local vc label:
remote vc label:
tunnel policy:
primary or secondary:
forwardEntry exist or not:
forward entry active or not:true
manual fault set or not:
AC OAM state:
BFD for PW session index:
BFD for PW state:
BFD for LSP state:
Local C bit is set,
local vc state:
remote vc state:
local ce-id:
local ce name:
remote ce-id:
intf(state,encap):
peer id:
route-distinguisher:
local vc label:
remote vc label:
tunnel policy:
primary or secondary:
forwardEntry exist or not:
forward entry active or not:false
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
residual time :--
residual time :--
Remote Remote
Encap VC Label
vlan 23552
vlan 23552
up
up
1
ce1
2
Vlanif11(up,vlan)
3.3.3.3
100:2
23552
23553
p1
primary
true
not set
up
256
up
true
Remote C bit is set
id: 0x20002
up
up
1
ce1
3
Vlanif11(up,vlan)
2.2.2.2
100:3
31745
35843
default
secondary
true
5 VLL Configuration
C MTU/ N S
Bit CELLS Bit Bit
1 1500 1 0
1 1500 1 0
484