Example For Configuring Ldp Hvpls - Huawei quidway s7700 Configuration Manual

Quidway S7700 Smart Routing Switch
Configuration Guide - VPN

7.13.4 Example for Configuring LDP HVPLS

Networking Requirements
As shown in
access the basic VPLS fully-connected network through UPEs and CE3 accesses the network
through a PE.
Figure 7-15 Networking diagram for configuring LDP HVPLS
CE1
Device
UPE
SPE
PE
Issue 01 (2011-07-15)
#
vlan batch 40
#
interface Vlanif40
ip address 10.1.1.2 255.255.255.0
#
interface GigabitEthernet1/0/0
port link-type trunk
port trunk allow-pass vlan 40
#
return
Figure 7-15, Site 1, Site 2, and Site 3 belong to the same VPLS; CE1 and CE2
GE1/0/0
Loopback1
1.1.1.9/32
GE3/0/0
UPE
GE2/0/0
GE1/0/0
GE1/0/0
Site1
Interface
GigabitEthernet 1/0/0
GigabitEthernet 2/0/0
GigabitEthernet 3/0/0
Loopback1
GigabitEthernet 1/0/0
GigabitEthernet 2/0/0
Loopback1
GigabitEthernet 1/0/0
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Basic VPLS full mesh
Loopback1
2.2.2.9/32
GE2/0/0
SPE
GE1/0/0
CE2
Site2
VLANIF Interface
VLANIF 10
VLANIF 20
VLANIF 30
-
VLANIF 30
VLANIF 40
-
VLANIF 40
7 VPLS Configuration
Loopback1
3.3.3.9/32
GE1/0/0
PE
GE2/0/0
GE1/0/0
CE3
Site3
IP Address
-
-
100.1.1.1/24
1.1.1.9/32
100.1.1.2/24
100.2.1.1/24
2.2.2.9/32
100.2.1.2/24
754