Applying The Tunnel Policy To The Martini L2Vpn; Checking The Configuration - Huawei quidway s7700 Configuration Manual

Quidway S7700 Smart Routing Switch
Configuration Guide - VPN
A tunnel policy is created.
Step 3 Run:
tunnel binding destination dest-ip-address te tunnel interface-number [ down-
switch ]
The peer address is bound with the tunnel policy. The VPN data from the local end are transmitted
through the bound tunnel to the destination address.
If a TE tunnel is bound with the destination address, the VPN data is only transmitted to the
destination address through the bound tunnel. Note the following:
l Tunnel policy can be either in select-sequence mode or tunnel binding mode. Therefore, the
l One dest-ip-address of a PE device can only be bound with one tunnel. If multiple tunnels
l If the PE has multiple peers, a tunnel policy can be configured with multiple tunnel
----End

1.7.4 Applying the Tunnel Policy to the Martini L2VPN

After a tunnel binding policy is applied to an L2VPN, the VPN data is transmitted along the
bound tunnel.
Context
Different VPN services to the same destination on a PE must apply different tunnel policies, and
be bound with different TE tunnels.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The AC interface view is displayed.
Step 3 Run:
mpls l2vc ip-address vc-id tunnel-policy policy-name
The tunnel policy is applied to the VC.
----End

1.7.5 Checking the Configuration

After configuring L2VPN main tunnel binding, you can view information about the bound tunnel
policy, and interfaces of the bound tunnel.
Issue 01 (2011-07-15)
tunnel policy configured with the tunnel binding command cannot be then configured with
the tunnel select-seq command.
are bound, the last binding overwrites the previous one.
binding commands with different dest-ip-address.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 VPN Tunnel Management Configuration
26