Configuring Route Exchange Between Pe And Ce - Huawei quidway s7700 Configuration Manual

Quidway S7700 Smart Routing Switch
Configuration Guide - VPN
The BGP view is displayed.
Step 3 Run:
peer ipv4-address as-number as-number
The remote PE is specified as the peer.
Step 4 Run:
peer ipv4-address connect-interface loopback interface-number
The interface is used to set up TCP connections.
Step 5 Run:
ipv6-family vpnv6
The BGP IPv6 VPN address family view is displayed.
Step 6 Run:
peer ipv4-address enable
The VPN-IPv6 routing exchange on the peer is enabled.
----End

4.4.5 Configuring Route Exchange Between PE and CE

The routing protocol between a PE and a CE can be BGP4+, IPv6 static route, RIPng, OSPFv3,
or IS-ISv6.
Context
Choose one of the following configurations as required:
l
l
l
l
l
Procedure
l
Issue 01 (2011-07-15)
NOTE
The 32-bit mask IP addresses of the loopback interfaces must be used to establish the MP-IBGP peer
relationship between PEs. This can ensure the tunnel can be iterated. The route destined to the loopback
interface is advertised to the remote PE based on IGP on the MPLS backbone network.
Configuring BGP4+ Between PE and CE
Configuring Static Routes Between PE and CE
Configuring RIPng Between PE and CE
Configuring OSPFv3 Between PE and CE
Configuring IS-ISv6 Between PE and CE
Configuring BGP4+ Between PE and CE
Do as follows on the PE:
1. Run:
system-view
The system view is displayed.
2. Run:
bgp as-number
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 BGP MPLS IPv6 VPN Configuration
332