Huawei quidway s7700 Configuration Manual page 790

Quidway S7700 Smart Routing Switch
Configuration Guide - VPN
[P-Vlanif10] quit
[P] interface vlanif 10
[P-Vlanif20] mpls
[P-Vlanif20] mpls ldp
[P-Vlanif20] quit
# Configure SPE2.
[SPE2] mpls lsr-id 3.3.3.9
[SPE2] mpls
[SPE2-mpls] quit
[SPE2] mpls ldp
[SPE2-mpls-ldp] quit
[SPE2] interface vlanif 20
[SPE1-Vlanif20] mpls
[SPE1-Vlanif20] mpls ldp
[SPE1-Vlanif20] quit
[SPE2] interface vlanif 40
[SPE1-Vlanif40] mpls
[SPE1-Vlanif40] mpls ldp
[SPE1-Vlanif40] quit
# Configure UPE1.
[UPE1] mpls lsr-id 4.4.4.9
[UPE1] mpls
[UPE1-mpls] quit
[UPE1] mpls ldp
[UPE1-mpls-ldp] quit
[UPE1] interface vlanif 30
[UPE1-Vlanif30] mpls
[UPE1-Vlanif30] mpls ldp
[UPE1-Vlanif30] quit
# Configure UPE2.
[UPE2] mpls lsr-id 5.5.5.9
[UPE2] mpls
[UPE2-mpls] quit
[UPE2] mpls ldp
[UPE2-mpls-ldp] quit
[UPE2] interface vlanif 40
[UPE2-Vlanif40] mpls
[UPE2-Vlanif40] mpls ldp
[UPE2-Vlanif40] quit
After the configuration, run the display mpls ldp session command on UPEs, P, and SPEs. You
can see that the peer relationship is set up between SPE and UPE, or between SPE and P. The
status of the peer relationship is Operational. Run the display mpls lsp command, and you can
view the status of the LSPs.
Step 5 Set up remote LDP sessions between SPEs.
# Configure SPE1.
[SPE1] mpls ldp remote-peer 3.3.3.9
[SPE1-mpls-ldp-remote-1] remote-ip 3.3.3.9
[SPE1-mpls-ldp-remote-1] quit
# Configure SPE2.
[SPE2] mpls ldp remote-peer 1.1.1.9
[SPE2-mpls-ldp-remote-1] remote-ip 1.1.1.9
[SPE2-mpls-ldp-remote-1] quit
Step 6 Enable the MPLS L2VPN function and configure Martini VLLs on the UPEs.
# Configure UPE1.
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 VPLS Configuration
775