Huawei quidway s7700 Configuration Manual page 509

Quidway S7700 Smart Routing Switch
Configuration Guide - VPN
PE2
P
CE1
CE2
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
Data Preparation
To complete the configuration, you need the following data:
l
Pay attention to the mapping between the in-labels and out-labels on the PE and P. For the settings
of the out-label and the in-label, see
Procedure
Step 1 Configure the ID of the VLAN that each interface belongs to, as shown in
The configuration procedure is not mentioned here.
Step 2 Assign the IP addresses to the VLANIF interfaces on the CEs.
# Configure CE1.
[CE1] interface vlanif 10
[CE1-Vlanif10] ip address 100.1.1.1 24
[CE1-Vlanif10] quit
# Configure CE2.
[CE2] interface vlanif 40
[CE2-Vlanif40] ip address 100.1.1.2 24
[CE2-Vlanif40] quit
Issue 01 (2011-07-15)
Loopback1
GigabitEthernet1/0/0
GigabitEthernet2/0/0
Loopback1
GigabitEthernet1/0/0
GigabitEthernet2/0/0
Loopback1
GigabitEthernet1/0/0
GigabitEthernet1/0/0
Configure a bidirectional static LSP for the CCC connection between PEs. The LSP is
exclusively used by the CCC connection.
Enable MPLS L2VPN on the PEs. MPLS L2VPN need not be enabled on P.
Set up two connections: one from CE1 to CE2 and the other from CE2 to CE1.
Out-label and in-label of the remote CCC connection
NOTE
The packets sent from CE to PE must have VLAN tags.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
-
VLANIF 30
VLANIF 40
-
VLANIF 30
VLANIF 20
-
VLANIF 10
VLANIF 40
Figure 5-5.
5 VLL Configuration
1.1.1.9/32
10.2.2.1/24
-
3.3.3.9/32
10.2.2.2/24
10.1.1.2/24
2.2.2.9/32
100.1.1.1/24
100.1.1.2/24
Figure 5-5.
494