Dedicated Gpio - Port G - Freescale Semiconductor DSP56374 User Manual

Dedicated GPIO - Port G

Table 2-9. Enhanced Serial Audio Interface_1 Signals (continued)
Signal Name Signal Type
SDO0_1 Output
PE11 Input, Output, or
Disconnected
2.10 Dedicated GPIO - Port G
Signal
Type
Name
PG0 Input, Output, or
Disconnected
PG1 Input, Output, or
Disconnected
PG2 Input, Output, or
Disconnected
PG3 Input, Output, or
Disconnected
PG4 Input, Output, or
Disconnected
PG5 Input, Output, or
Disconnected
PG6 Input, Output, or
Disconnected
2-16
State during
Reset
GPIO Serial Data Output 0—SDO0_1 is used to transmit data
Disconnected from the TX0 serial transmit shift register.
Port E11—When the ESAI_1 is configured as GPIO, this
signal is individually programmable as input, output, or
internally disconnected.
The default state after reset is GPIO disconnected.
This pin has an internal pull-down resistor.
This input is 5 V tolerant.
Table 2-10. Dedicated GPIO - Port G Signals
State During
Reset
GPIO Port G0—This signal is individually programmable as input,
Disconnected output, or internally disconnected.
This pin has an internal pull-down resistor.
This input is 5 V tolerant
GPIO Port G1—This signal is individually programmable as input,
Disconnected output, or internally disconnected.
This pin has an internal pull-down resistor.
This input is 5 V tolerant
GPIO Port G2—This signal is individually programmable as input,
Disconnected output, or internally disconnected.
This pin has an internal pull-down resistor.
This input is 5 V tolerant
GPIO Port G3—This signal is individually programmable as input,
Disconnected output, or internally disconnected.
This pin has an internal pull-down resistor.
This input is 5 V tolerant
GPIO Port G4—This signal is individually programmable as input,
Disconnected output, or internally disconnected.
This pin has an internal pull-down resistor.
This input is 5 V tolerant
GPIO Port G5—This signal is individually programmable as input,
Disconnected output, or internally disconnected.
This pin has an internal pull-down resistor.
This input is 5 V tolerant
GPIO Port G6—This signal is individually programmable as input,
Disconnected output, or internally disconnected.
This pin has an internal pull-down resistor.
This input is 5 V tolerant
DSP56374 Users Guide, Rev. 1.2
Signal Description
Signal Description
Freescale Semiconductor