Connecting To The Target And Your Host Computer; Debug Port Connector Information - Freescale Semiconductor metrowerks CodeWarrior User Manual

Setting up the USB TAP Emulator

Connecting to the Target and your Host Computer

Connecting to the Target and your Host
Computer
To test your software using the USB TAP emulator, you must have working target
hardware.
This section explains how to connect the USB TAP emulator to such hardware and to
your host computer.
The topics in this sections are:
•

Debug Port Connector Information

• Setting the Debug Port Clock Frequency
• Connecting to your Host Computer
CAUTION
Debug Port Connector Information
The USB TAP emulator is a powerful development tool for use with a wide variety of
processors that use either JTAG/COP, DPI, BDM, OnCE or ARM® JTAG debug
interfaces
The appendices describe the debug port connector informations for:
• "JTAG/COP Connector Information" on page 27.
• "DPI Connector Information" on page 33.
• "BDM Connector Information" on page 37.
• "OnCE Connector Information" on page 43.
• "ARM JTAG Connector Information" on page 47.
14
The USB TAP emulator contains components that are subject to
damage from electrostatic discharge. Whenever you are using,
handling, or transporting the USB TAP emulator, or connecting to or
disconnecting from a target system, always use proper anti-static
protection measures, including using static-free bench pads and
grounded wrist straps.
USB TAP Users Guide