Table 2-20. Cascade Mode Encoding; Table 2-21. Tie Mode Encoding - Motorola MVME5100 Programmer's Reference Manual

M
TIE
http://www.motorola.com/computer/literature
CASCADE MODE. Allows cascading of an external
8259 pair connected to the first interrupt source input pin
(0). In the pass through mode, interrupt source 0 is passed
directly through to the processor 0 INT pin. MPIC is
essentially disabled. In the mixed mode, 8259 interrupts
are delivered using the priority and distribution
mechanism of the MPIC. The Vector/Priority and
Destination registers for interrupt source 0 are used to
control the delivery mode for all 8259 generated interrupt
sources.

Table 2-20. Cascade Mode Encoding

M
0 Pass Through
1 Mixed
Tie Mode. Writing a one to this register bit will cause a tie
in external interrupt processing to swap back and forth
between processor 0 and 1. The first tie in external
interrupt processing always goes to Processor 0 after a
reset. When this register bit is set to 0, a tie in external
interrupt processing will always go to processor 0 (Mode
used on Version $02 of MPIC).

Table 2-21. Tie Mode Encoding

T
0 Processor 0 always selected
1 Swap between Processor's
Mode
Mode
Registers
2
2-115