Board Eprom/Flash Mode (S4); Preparing The Transition Module - Motorola MVME167P Installation And Use Manual

Board EPROM/Flash Mode (S4)

The MVME167P and MVME177P single-board computers share a
common board artwork. The two segments of switch S4 jointly define the
board EPROM controller model (MVME167 EPROM-only or MVME177
EPROM/Flash) to be emulated when the board initializes.
With S4 segment 1 set to OFF (factory configuration in the MVME167P
case), firmware recognizes the board as an MVME167P. Setting S4
segment 1 to ON initializes the board in MVME177P mode.

Preparing the Transition Module

The MVME167P supports the MVME712B transition module, which (in
conjunction with an LCP2 adapter board) supplies SCSI and Ethernet
connections. It also supports the MVME712M transition module, which
(in conjunction with a P2 adapter board) supplies serial and parallel I/O in
addition to SCSI and Ethernet connections.
For details on configuring an MVME712B or MVME712M for use with
the MVME167P, refer to the transition module documentation listed in
Appendix E, Related
http://www.motorola.com/computer/literature
S4
ON
2
1
Documentation.
Board EPROM/Flash Mode (S4)
OFF
MVME167 EPROM-only mode
(factory configuration)
2736 0004 (3-3)
1
1-11