Cleaning The Press; Cleaning The Exterior; Clean Fuser Assembly Information - Xerox Versant 3100 Press User Manual

Maintenance

Cleaning the Press

Read and adhere to the following information when cleaning the press:
• Before you start to clean the press, be sure to switch off the power using the circuit
breaker switch and unplug the press.
Warning
Cleaning the press without switching off the power may cause an electric shock.
• Always use a dry lint-free cloth for all cleaning actions unless otherwise directed.
Caution
Do not use benzene, paint thinner, other volatile liquids, or spray insect repellent on
the press as doing so may discolor, deform, or crack covers.
• If a moistened cloth is used, wipe afterwards with a dry lint-free cloth.
Caution
Cleaning the press with an excessive amount of water may cause the press to
malfunction and/or damage documents during printing.

Cleaning the Exterior

1. Wipe the exterior with a soft cloth moistened with water. If dirt is difficult to remove,
try gently wiping with a soft cloth moistened with a small amount of neutral detergent.
2. Wipe off any excess water from the exterior with a soft cloth.

Clean Fuser Assembly Information

Run the Clean Fuser Assembly routine from the Tools menu when you encounter an
image quality issue caused by contaminants in the fuser. For example, use this feature
when you see dry ink / toner debris on the back side of prints.
The press automatically runs this routine periodically, but if you see image quality
problems with dry ink / toner on the back of prints, you can initiate this procedure
manually in order to resolve the issue.
6-2
® ®
Xerox Versant 3100 Press
User Guide