Selector Shaft; Removal; Installation - Triumph 2012 Tiger 800 Service Manual

Transmission

Selector Shaft

Removal

1. Note the position and orientation of the gear pedal
crank in relation to the shaft, then remove the cran k.
2. Remove the E-clip and washer from the gear pedal
end of the gear change -shaft.
kakh1
1. Gear change shaft
2. E-clip
3. Washer
3. Remove the clutch (see page
4. Un-hook the spring from the detent arm.
5. Withdraw the gear change shaft and detent arm
from the cl utch end of the crankcase.
cgh
1. Gear change shaft
2. Detent arm
3. Detent arm spring
6. Collect the detent spring.
7.6
1
4-6>.
-
SeiVice Manual Tiger 800 and Tiger 800XC

Installation

Z Rotate the selector drum to the neutral position.
cglv
1. Detent wheel
2. Neutral position
8. Using grease to N LG I 2 specification, lubricate the
lip of the seal on the gear change shaft.
�
- � .
1. Gear change shaft seal
2. Gear change shaft bearing
Take care to avoid damaging the lip of the seal when
inserting the gea r change shaft into the crankcase. A
damaged seal will lead to oil loss and could result in
engine damage.
9. Carefully insert the gear pedal end of the shaft
through the bearings and lip seal in the cran kcase.
Support the detent arm bearing clear of the selector