Triumph 2012 Tiger 800 Service Manual page 170

Lubrication
Installation
1 . Fit a new 0-ring to the heat excha nger, a n d a new
sealing washer to the centre bolt.
1. Centre bolt
2. Sealing washer
3. Heat exchanger
4. 0-ring
Note:
To ensure correct positioning, ensure that
•
the tab on the heat exchanger locates in the
boss provided in the crankcase.
Do not rely on the tab to hold the heat exchanger in
position while tightening the centre bolt. The tab will
bend and will not prevent the heat exchanger from
turning. Instead, firmly hold the heat exchanger in
position by hand.
cgy q
1. Heat exchanger tab
2. Crankcase boss
8.18
SeiVice Manual Tiger 800 and Tiger 800XC
-
2. Fit the heat exchanger to the crankcase and tighten
59
the centre bolt to
Nm.
3. Fit the coolant hoses to the heat exchanger and
tighten the coolant hose clips.
cgye
1. Heat exchanger
2. Centre bolt
3 . Coolant hose clips
4. Refill the cooling system (see page
5. Refill the engine with oil <see page 8- 7>.
6. Reconnect the battery, positive <red) lead first.
Z Start the engine and check for oil leaks. Once a leak
check has been made, stop the engine and allow to
stand for 3 minutes.
8. Adjust the engine oil level (see page 8- 6>.
9. Refit the rider's seat <see page
1 1 -S>.
·
16- W.