Installation - Triumph 2012 Tiger 800 Service Manual

Note:
•
Two shorter bolts are fitted at the end
adjacent to the camshaft drive chain.
ra
Camshaft Cover Bolt Release Sequence
8. Remove the camshaft cover from the motorcycle.
Never use a lever to remove the camshaft cover from
the head.
Using a lever will cause damage to the head and
camshaft cover wh ich could lead to an oil leak.
9.
Remove the camshaft cover gasket. If necessary,
recover the three dowels from the camshaft ladder
<these may come away in the camshaft cover or
gasket>.
10. Discard the camshaft cover gasket and bolt seals.
1 1. Remove any residual oil from the front of the head
using a syringe or lint free cloth.
Service Manual Tiger 800 and Tiger SOOXC
-

Installation

1. Refit the three dowels to the camshaft ladder.
1. Dowels
2.
Fit a new camshaft cover seal to the cylinder head.
Ensure the groove in the gasket is correctly seated to
the head. Ensure the plug tower seals and the dowels
are correctly located.
JQV
1. Camshaft cover seal
2. Dowels
3. Plug tower seals
3 .
Fit the camshaft cover, ensu ring that the gasket
remains in the correct position.
4. Lubricate the new camshaft cover screw seals with
clean engine oil. Fit the camshaft cover screws and
screw seals and tighten u ntil finger tight.
5. Finally, tighten the ca mshaft cover screws, in the
same order as for remova l, to
6. Refit the throttle bodies, injectors and fuel rail to the
cyl inder head <see page 10-ton.
Z Check the throttle
page 10-104>.
Cylinder Head
10 Nm.
cable adjustment (see
3.7