Front Suspension
cgjo
1. Headstock top nut
Z
Ease the top yoke from the forks and support while
detached.
13.16
-
Service Manual
Tiger 800 and Tiger 800XC
8.
Adjust the bearing free-play as follows, all using tool
T3 88002 3 :
Remove the locknut and tab w asher.
Slacken the adjuster nut then tighten to
4 0Nm.
•
Slacken the adjuster nut, then re-tighten to
15 Nm.
•
Fit the tab w asher and lock nut
lt is essential that the adjuster nut is not over-tightened.
If the adjuster is over-tightened it will cause a pre-load
on the headstock bearings. This will introduce tight
steering, which could cause loss of control and an
accident.
•
Hold
the
adjuster
tightening the locknut to
cdbp
Tool T3880023
1. Adjuster nut
2. Locknut
nut
in
position
w hile
4 0 Nm.