Gear Position Sensor - Triumph 2012 Tiger 800 Service Manual

Fuel System/Engine Management

Gear Position Sensor

Fault Code
P0705
Pinpoint Tests
Test
1 Check cable and terminal integrity:
- ECM pin 824
2 Check cable for short circuit:
- ECM pin 824 to ground
3 Check cable for continuity:
- ECM pin 824 to sensor pin 1
- ECM pin 820 to sensor pin 2
- ECM pin A31 to sensor pin 3
4 Check cable for short circuit:
- Sensor pin 1 to sensor pin 2
- Sensor pin 1 to sensor pin 3
5 Reconnect harness, clear fault code
10.68
Possible cause
Gear position sensor circuit fault
Result
OK
Fau lty
OK
Short circuit
OK
Open circuit
O K
Short circuit
O K
Fault still present
SeiVice Manual Tiger 800 and Tiger 800XC
-
Action
&
View note 'freeze frame' data if
available.
&
View note 'sensor' data.
Ensure sensor connector is secure.
Disconnect ECM and proceed to
pinpoint test 1 :
Action
Disconnect sensor and proceed to test 2
Rectify fault, proceed to test 5
Proceed to test 3
Locate and rectify wiring fau lt, proceed to
test 5
Proceed to test 4
Locate and rectify wiring fault, · proceed to
test 5
Renew gear position sensor and contact pin
and proceed to test 5
Locate and rectify wiring fault, proceed to
test 5
Action complete, quit test
Contact Triumph service