Low Oil Pressure Warning Light Switch; Removal; Installation - Triumph 2012 Tiger 800 Service Manual

Lubrication
12. Install three new 0-rings to the coolant outlet pipe
and position the pipe through the crankcase, locating
it to the water pump outlet. Install a new fixing and
tighten to
12 Nm.
cglr
1. Coolant outlet pipe
2. Fixing
1 3 . Install a new 0-ring to the o i l pick-up a n d refit the oil
pick-up. Fit new bolts and tighten to
14. Install two new 0-rings to the oil transfer pipe and
refit the oil transfer pipe. Fit new bolts and tighten to
12 Nm.
15. Refit the clutch (see page
16. Refit the sump, ensuring the water pump drain tube
is correctly installed (see page
1Z Reconnect the battery, positive <red lead) first.
18. Refit the rider's seat <see page
19. Refill the engine with oil (see page
20. Refill the cooling system (see page
8.14
12 Nm.
4- 10>.
8- 16).
16- 13).
8-7>.
1 1 -5>.
SeNice Manual Tiger 800 and Tiger 800XC
-
Low Oil Pressure Warning Light
Switch
The low oil pressure warning light switch is located in the
upper crankcase, behind the cylinder head.

Removal

1. Low oil pressure warning light switch

2. Electrical connection
1. Remove the rider's seat <see page
2. Disconnect the battery, negative <black> lead first.
3 . Disconnect the electrical con nection to the switch.
4. Remove the switch and collect the copper washer.

Installation

1. I ncorporating a new copper washer, fit the switch
and tighten to
13 Nm.
2. Refit the electrical connection.
3. Reconnect the battery, positive (red) lead first.
4. Refit the rider's seat <see page
16- 13>.
16- 13).