Triumph 2012 Tiger 800 Service Manual page 101

2 . Place the assembled clutch pack on a flat surface and
measure its height as shown below.
T0943_1
1. autch pack height
3. The correct clutch pack height for this clutch
assembly is shown in the table below.
Standard height in mm
42.20
4. If the clutch pack height measurement is incorrect,
proceed as described below/opposite:
Clutch Pack Height Too High
Note:
No more than three
•
plates are to be used in the clutch pack.
1.
Replace the 2.0 mm steel plate next to the 1.6 mm
steel plate (indicated below) with a new 1.6 mm steel
plate.
Clutch outer
1. 2.0 mm steel plate to be replaced
2. 1.6 mm steel plates
2. Re-check the clutch pack height as described earlier.
Tolerance in mm
+0.34/-0.66
1.6 mm thick steel
...
SeiVice Manual Tiger 800 and Tiger
-
Clutch Pack Height Too Low
Note:
A t least one 1 . 6 m m steel plate must b e in
•
the clutch pack.
If the clutch pack height is too low, replace the
1.
1.6 mm steel plate indicated below with a new
2.0 mm steel plate.
���� � � � � � � � � � � � � �
T0944_2
1. 1.6 mm steel plate to be replaced
2. Re-check the clutch pack height as described earlier.
SOO X C
Clutch
I
1
...
Clutch outer
4.9