Triumph 2012 Tiger 800 Service Manual page 282

Fuel System/Engine Management
Ignition Switch and Immobiliser
Antenna
Note:
•
The immobiliser antenna is integral to the
ignition switch and
separately.
Removal
Remove the rider's seat <see page 16-13>.
1.
2 . Disconnect the battery, negative (black> lead first.
Remove the fuel tan k (see page 10-91).
3 .
Remove t h e two screws and remove t h e ignition
4.
switch cover.
Without damaging t h e ignition switch and u s i n g a
5.
suitable dri l l, careful ly drill out the head of the shear
bolts secu ring the ignition switch to the frame.
1. Ignition switch and immobiliser antenna
2. Shear bolts
Disconnect the ignition switch m u ltiplug.
6.
Noting the harness routing, remove ignition switch.
Z
Remove the remainder of the shea r bolt from the
8.
frame.
Installation
Installation is t h e reverse of removal, noting the
1.
following:
Install new shear bolts and tighten until the
•
heads shear off.
10.104
cannot be serviced
SeNice Manual Tiger 800 and Tiger 800XC
-
Throttle Cable
Adjustment
Note:
•
Minor adjustments to the opening cable can
be made using the adjuster near the throttle
grip end of the throttle. Where a correct
setting cannot be achieved this way, the
adjusters at the throttle end of both cables
must be used. The opening cable must be
set first followed by the closing cable.
1. Throttle grip
2. Correct setting, 2-3 mm
Remove the rider's seat (see page 16-13>.
1.
Disconnect t h e battery, negative (black> lead first.
2.
Set the 'open ing' cable adjuster a t the throttle grip
3 .
end such that it has a n eq ual amount of adjustment
in each direction. nghten the locknut.
Remove the fuel tan k (see page 10-91>.
4.