Triumph 2012 Tiger 800 Service Manual page 285

Locate the outer cables to the bracket and adjust
6.
until the start of the thread is
back of the throttle cable bracket. Secure the adjuster
and locknuts.
1. Opening cable
2. Closing cable
Refit the throttle bod ies <see page 10-101).
Z
Set the throttle cable adjustment <see page 10-104>.
8.
Refit the airbox <see page 10-101).
9.
Refit the fuel tan k <see page 10-92>.
10.
Reconnect the battery, positive (red) lead first
1 1.
Refit the rider's seat <see page 16-13).
12.
mm away from the
14
Se1Vice Manual Tiger 800 and Tiger 800XC
-
Fuel System/Engine Management
Throttle Bodies/lniectors
Removal
Note:
•
Because fuel stored in the fuel rail will be at
3 bar pressure, it is essential that the fuel
pressure is reduced before any dismantling
of the fuel rail
pressure, briefly crank the engine with the
fuel pump disconnected.
If the fuel rai l is dismantled without first reducing
pressu re fuel may esca pe
components to be coated with fuel.
Th is would represent a serious fire haza rd wh ich could
lead to burn injuries and damage to property.
Remove the rider's seat (see p a g e 16-13).
1.
Disconnect the battery, negative (black> lead first.
2 .
Remove the fuel ta n k (see page 10-91).
3 .
Remove the airbox (see page
4.
Disconnect t h e th rottle position sensor m ulti-plug.
5.
Discon nect the fuel i n jector m u lti-pl ugs.
6.
Disconnect the idle speed control stepper motor
Z
m u lti-plug.
Release the cl ips securing the throttle bodies to the
8.
transition pieces.
1. Transition piece Cone per cylinder>
2. Clip location (throttle bodies removed for clarity>
Ease the th rottle bodies from the transition pieces
9.
and lay the assembly careful ly on the cam cover.
Release both th rottle cables from the th rottle cam
10.
<see page 10-105>.
takes place. To reduce
ca using cloth ing and
10-98).
10. 107