Throttle Position Sensor - Triumph 2012 Tiger 800 Service Manual

Fuel System/Engine Management

Throttle Position Sensor

Fault Code
P01 2 2
P01 2 3
Pinpoint Tests
Test
1 Check cable and terminal integ rity:
- ECM pin 801
- ECM pin 820
- ECM pin A10
2 Check cable for short circuit:
- ECM pin A 10 to ground
3 Check cable continuity:
- ECM pin A 10 to sensor pin 1
- ECM pin 820 to sensor pin 2
- ECM pin 801 to sensor pin 3
4 Check cable for short circuit:
- ECM pin A 10 to ECM pin 801
- ECM pin A 10 to ECM pin 820
5 Reconnect harness, clear fault code and run O K
engine to verify fault cleared
10.46
Possible cause
Throttle position sensor low input View
voltage <short to ground or open 'freeze frame' data if available.
circuit>
Throttle position sensor high input 'sensor' data.
voltage <short circuit to sensor supply)
Result
O K
Faulty
OK
Short circuit
O K
Open circuit
OK
Short circuit
Fault still present
SeNice Manual Tiger 800 and Tiger 800XC
-
Action
& note diagnostic software
&
View note diagnostic software
Ensure sensor connector is secure.
Disconnect ECM and proceed to
pinpoint test 1 :
Action
Disconnect sensor a n d proceed to
test 2
Rectify fault, proceed to test 5
Proceed to test 3
Locate and rectify wiring fau lt, proceed to
test 5
Proceed t o test 4
Locate and rectify wiring fau lt, proceed to
test 5
Renew throttle position sensor, proceed to
test 5
Locate and rectify wiring fault, proceed to
test 5
Action complete - quit test
Contact Triumph service