Shaft, Input Kit - A9618064 (Spares Only); Gear, Output Kit - A9618065 (Spares Only); Wheel Detent Kit - A9618068 (Spares Only) - Triumph Daytona 675 User Manual

14. Fit the new race kit clutch spacer (3)
onto the input shaft adjacent to the
bearing.
NOTE
• The race kit clutch spacer replaces
the standard clutch spacer. The
standard clutch spacer cannot be
used in conjunction with the race
kit and must be discarded.
Shaft, Input Kit - A9618064
(Spares kit only - Must not be fitted in isolation to a standard engine.)
Item Description
1 Input shaft assembly, race
5 Bolt, reduced hex head flange, M6 x 20, black, encapsulated
6 Circlip, 28 mm shaft
Gear, Output Kit - A9618065
(Spares kit only - Must not be fitted in isolation to a standard engine.)
Item Description
2 Gear, output 1st, 37T, race
Wheel Detent Kit - A9618068
(Spares kit only - Must not be fitted in isolation to a standard engine.)
Item Description
7 Wheel, detent, race
8 Screw, Torx, pan head, M6 x 1.0 x 20, black
© Triumph Designs Ltd 2008.
15. Fit the selector drum assembly into the
crankcase following the procedures
detailed in section 7 of the Daytona 675
service manual.
16. Fit the
crankcase following the procedures
detailed in section 7 of the Daytona 675
service manual.
Page 26 of 33
output assembly into the
Qty
1
3
2
Qty
1
Qty
1
1