Triumph 2012 Tiger 800 Service Manual page 267

lmmobiliser/TPMS Control Module Fault
Note:
•
Refer to the owner's handbook for the wheel pressure sensors I D numbers .
Fault Code
L0007
Possible cause
l mmobiliser/TPMS control module
has lost communication with the front
and rear wheel sensor units.
Low battery voltage.
Wrong sensor ID numbers have been
registered in the immobiliser/TPMS
control module
SeiVice Manual Tiger 800 and Tiger 800XC
-
Fuel System/Engine Management
Action
Using t h e Triumph diagnostic tool,
check that the correct I D num bers for
the wheel pressu re sensors are
registered to the l mmobiliser/TPMS
control module.
If the correct I Ds are registered,
replace the front and rear wheel
pressure sensor following the
procedure described in the Triumph
diagnostic tool user guide.
Record the new sensor's ID number
into the owner handbook before
fitting.
10.89