Triumph 2012 Tiger 800 Service Manual page 297

10. Remove the bolt from the header pipe rear
mounting point.
1. Header pipe rear mounting bolt
1 1. Detach the header pipe assembly and collect the
seals from the cylinder head ports.
1 2 . I f necessary, remove the remove the oxygen sensor.
SeiVice Manual Tiger 800 and Tiger 800XC
-
Fuel System/Engine Management
Assembly
1.
If removed, install the oxygen sensor and tig hten to
2 5 Nm.
2.
Fit new seals to the cylinder head. Ensure that the
face of the seal with the tab is facing the cylinder
head.
Note:
•
A smear of grease may be used to retain the
seals in the cylinder head during assembly.
1. Cylinder head
2. Seal
3. Seal tab
3 .
Locate the header pipes and a l i g n the header pipe
flanges to the fixing points. Fit new nuts and hand
tighten.
4. Assemble the rear mounting point fixing but do not
tighten at this stage.
10. 1 19