Front Abs Wheel Sensor; Removal; Installation - Triumph 2012 Tiger 800 Service Manual

Brakes

Front ABS Wheel Sensor

Removal

!
Before starting work, ensu re the motorcycle is stabilised
and adequately supported. This will help prevent it from
falling and causing injury to the operator or damage to
the motorcycle.
1. Disconnect the battery negative (black> lead first.
2. Remove the rider's seat (see page 16-13>.
3 . Remove the fuel tank (see page 10-91>.
Note:
•
Note the routing of the harness and its
retaining clips for installation.
4. Disconnect the wheel speed sensor multipl ug,
Identified as the white connector, located below the
ignition switch.
5. Release the wheel speed sensor harness from the
brake hose clips.
6. Release the bolt and remove the sensor. Collect the
shim from between the sensor and fork leg and
discard the bolt.
[)
cg zb
1. Front ABS wheel speed sensor
2. Bolt
14.34
SeNice Manual Tiger 800 and Tiger SOOXC
-

Installation

Note:
•
Check the condition of the shim before use.
Do not use a shim which is bent or
damaged.
1. Position the wheel speed sensor to the fork leg with
its shim between the
Temporarily fit the original bolt and tighten to
2. The air gap between the wheel speed sensor and the
pulser ring must be between 0.1 m m and 1.5 mm.
Check and adjust the wheel speed sensor air gap as
described on page 14-3 8.
3 . Once the wheel speed sensor a i r g a p measurement
is correct, install a new bolt (if not already replaced
during air gap adjustment) and tighten to
4. Route the harness and secure to the brake hose clips
as noted for removal.
5.
Con nect the wheel speed sensor multiplug.
6. Refit the fuel tank (see page 10-91>.
Z Connect the battery, positive (red) lead first.
8. Refit the rider's seat (see page 16-13).
9. Check that the brakes operate correctly.
sensor and fork leg.
9 Nm.
9 Nm.