Installation - Triumph 2012 Tiger 800 Service Manual

Transmission
3 . With the sprag clutch mounted in the housing, check
the sprag clutch for smooth, free movement in one
direction only (as indicated by the arrow marked on
the sprag clutch body>.

Installation

1. Locate the sprag clutch to the housing as shown
below. Push firmly . until the lip seats in the recess
provided in the housing.
1. Sprag clutch housing
2. Sprag clutch assembly
7.22
SeNice Manual - Tiger 800 and Tiger 800XC
Fit the housing to the alternator rotor.
2.
3. Ensure that the housing is squarely seated
jammed on the rotor. I nstall new fixings.
4. Working in the sequence shown, tighten the bolts to
Once all six bolts have been tig htened, go
16 Nm.
around again in sequence and recheck each bolt is
correctly torqued, if any bolt moves, go around
again. Repeatedly check the bolts in sequence until
all are correctly torqued and do not move when
checked, this will ensure the sprag cl utch housing is
correctly seated on the rotor.
Bolt Tightening Sequence
5. Fit the starter drive gear to the sprag clutch.
cdnb
1. Starter drive gear
2. Sprag clutch housing
3 . Alternator rotor
· a nd is not