Triumph 2012 Tiger 800 Service Manual page 270

Fuel System/Engine Management
Note:
•
Before disconnection, note the position of
the two breather hoses so that they can be
returned to the
refitting the tank.
1 1. Disconnect the two breather hoses.
1. Breather hose - fuel tank vent
2. Breather hose - filler neck over flow
12. Remove the fuel tank from the frame.
10.92
same locations when
SeiVice Manual Tiger 800 and Tiger SOOXC
-
Installation
1. Position the fuel tank to the frame.
2. Connect the two breather hoses as previously noted.
Note:
•
The fuel hose
connectors on each end, to aid orientation.
The grey end must be fitted to the fuel tank,
the orange end must be fitted to the fuel
rail.
3. Recon nect the fuel feed hose by gently pushing
inwards until the hose engages with a click.
4.
Slide the double check latch down <i.e. towards the
spigot> until the release buttons are covered. If the
latch will not slide into position, then the fuel hose is
not fully home on its spigot and must therefore be
refitted correctly.
5. Reconnect the fuel pump electrical connection.
6. Reconnect the fuel level sensor.
1. Fuel hose
2. Fuel pump electrical connection
3. Fuel level sensor connection
Z Align the fuel tank to the mounting points. Fit and
tighten the two rear bolts to
8.
Refit the fuel tank infill panels (see page
9. Refit the cockpit assembly <see page
10. Refit the upper radiator panels (see page
1 1 .
Refit the lower radiator panels <see page
1 2 .
Reconnect the battery, positive (red) lead first.
1 3 . Start the engine a n d check careful ly for fuel leaks.
Rectify as necessary.
14. Refit the rider's seat <see page
-has different coloured
1 2 Nm.
16-2 1 ).
16-2 1).
16-21).
16-21).
16-13).