Oxygen Sensor - Triumph 2012 Tiger 800 Service Manual

Fuel System/Engine Management

Oxygen Sensor

Fault Code
P0130
Pinpoint Tests
Test
1
Check cable and terminal integrity:
- ECM pin A26
- ECM pin 820
2 Check cable for short circuit:
- ECM pin A26 to ECM pin 820
- ECM pin A26 to ECM pin A06
3 Check cable contin uity:
- ECM pin A2 6 to sensor pin 2
- ECM pin 820 to sensor pin 1
4 Reconnect harness, clear fault code and run OK
engine. Check adaptation status
Circuit Diagram
10.58
Possible cause
Oxygen sensor circuit fault
Result
O K
Fau lty
OK
Short circuit
OK
Open circuit
Fault stil l present
EMS Main Relay
Lambda Sensor
SeiVice Manual Tiger 800 and Tiger 800XC
-
Action
& note 'freeze frame' data if
View
available.
&
View note 'sensor' data.
Ensure sensor connector is secure.
·
Disconnect ECM and proceed to
pinpoint test 1 :
Action
Disconnect oxygen sensor and proceed to
test 2
Rectify fau lt, proceed to test 4
Proceed to test 3
Locate and rectify wiring fau lt, proceed to
test 4
Proceed to test 4
Locate and rectify wiring fau lt, proceed to
test 4
Action complete - quit test
Contact Triumph service
ECM