About entering media thickness and remaining amount
When you set "Media remaining amount display" and "Media detection" to "ON" and "MANUAL", input screen
for the media thickness and the remaining amount is displayed after detecting the media width.
1
Display the screen for entering media remaining
amount.
2
Press
3
Press the
Changing the printing origin
The position of the printing origin can be changed.
1
In Local, Press
• It enters into the origin setting mode.
2
Press
• Select the carriage and media, moving the point with
• When you press the
media cutting.
3
After determining the origin, press the
• The printing origin is changed.
2-24
to enter the media remaining amount.
key.
.
to set the origin to a desired position.
.
key here, you can perform
Setting a Media
I n p u t
o f Me d i a L e n g t h
=
I n p u t
o f Me d i a L e n g t h
=
OR I G I N SE T UP
0 . 0
OR I G I N SE T UP
0 . 0
Origin
(Length)
key.
OR I G I N SE T UP
* * OR I G I N * *
* * . * m
* * . * m
- - - -
0 . 0
Origin
(Width)