MIMAKI Tx500-1800B Operation Manual page 93

Printing the Remaining Amount of a Media
The present remaining amount of a media can be printed.
• Set "Remaining amount of a media to display" to "ON".
• When you replace the media you use now with another, it is recommended that you print the
remaining amount of the media on it.With the remaining amount of a media having been printed
beforehand, when you use the replaced media again, you can enter an accurate value in the screen
for entering the remaining amount of a media (
1
In LOCAL, Press
• LOCAL changes to the origin setting mode.
2
Press
• Move the carriage and media with
the origin.
• When you do not change the origin, do not press
• When you press the
and the screen returns to LOCAL.
3
Press the
• When you press
Step 2.
• When you press the
4
Press the
• The remaining amount of a media starts to be printed.
• When the printing has been completed, the screen returns to LOCAL.
• When the remaining amount of a media has been printed with the origin changed, the origin set here
is effective even when subsequent data are printed.
.
to change the value of the origin.
and proceed to Step 3.
key here, the origin is changed,
key.
, the screen returns to
key, the screen returns to LOCAL.
key.
P.2-24) that appears after media detection.
OR I G I N SE T UP
0 . 0
and set
OR I G I N SE T UP
0 . 0
Origin
(Length)
MED I A REMA I N PR I N T
Machine Settings
- - - -
0 . 0
Origin
(Width)
[ EN T ]
3-15
1
1
3
5
6