Table of Contents
Advertisement
Chapter 2 Basic Operation
Notes when using fabric reterner
• When installing the media, align the media's right
edge with the groove in the platen. Placing the
media rightward of the groove will make it rise up if
it moves obliquely, and this could cause damage
to the head.
• If a media is misaligned to the right/left more than
fixed position, a error message "MEDIA SET
POSITION R" or is displayed. Set the media
again.
Groove
Fabric reterner
Media
2-22
Changing the printing origin
The position of the printing origin can be changed.
Moving the LED pointer to the changing position and
deciding the position.
In Local, Press
1
• It enters into the origin setting mode.
SET ORIGIN
X
0.0
Press
2
point of the LED pointer to thechanging
position.
• Select the carriage and media, moving the point
with [][][][].
After determining the origin, press the
3
key.
• The printing origin is changed.
.
Y
0.0
40° /50°
to set a light
Advertisement
Table of Contents
