Changing The Printing Origin - MIMAKI JV400-LX Series Operation Manual

Changing the printing origin

The position of the printing origin can be changed.
Moving the LED pointer to the changing position and deciding the position.
When the heavy-duty feeding / take-up device is not used
1
In Local, Press
• It enters into the origin setting mode.
2
Set a light point of the LED pointer to the changing position by pressing
• Select the carriage and media, moving the point with
• When you press the
media cutting.
3
After determining the origin, press the
• The printing origin is changed.
Typical setting position of printing origin
The printing origin in the depth direction (X') is positioned at about 75 mm rearward from the slot for cutting on
the platen. The printing origin in the scanning direction (Y') is positioned at 15 mm from the right end of the
media. The value in the scanning direction (Y') can be changed using [MARGIN] in FUNCTION mode.
( P.3-1) This can be changed by using the Jog key.
2-16
.
.
.
key here, you can perform
slot for cutting
approx. 75 mm
key.
25 mm
(Y')
(X')
Setting a Media
OR I G I N SE T UP
0 . 0 - - - -
OR I G I N SE T UP
0 . 0 0 . 0
Origin Origin
(Length) (Width)
OR I G I N SE T UP
* * OR I G I N * *